Home water purifier | portable water purifiers | water dispenser | industrial water treatment equipment | Shenzhen Science and Technology Development Co., Ltd. belongs to Hong Quan Series: Water Purifier Product Model: KLQ-CSW400 Specifications: 470 * 320 * 650 ( mm) of raw water: municipal tap water pressure :0.1-0 .4 Mpa Inlet and outlet: 2 minutes whether electricity: electricity needs raw water temperature 5-45 degrees Celsius filter precision: 0.0001 micron water production: 67L / H flushing mode: Auto flushing power: 220V filter combination: PP cotton + compressed carbon + granular activated carbon (RO reverse osmosis membrane) + inhibitory coconut shell activated carbon water purification water quality: better than "drinking water health standards", in which micro-organisms, turbidity indicators achieve drinking water standards (GB17324-2003); Note: the use of the process is often recommended to wash, you can extend the life of the filter; pure water installation method: 1, turn off the water, turn on the tap, let go of the tube remaining water. 2, remove the faucet inlet pipe, installed water tee and tighten with a wrench (install water three links, you do not wrapped around the raw material with rubber gasket connector.) 1 | 4 the inlet valve wrapped around exceedingly material straps to the water three links at the side of the hole, the water inlet is installed in the inlet tee and tighten with a wrench. 3 Close the water inlet valve, open water, wipe with a paper towel to check whether the installed joint seepage. 4, PP cotton, granular activated carbon, compressed carbon the three filter order into the filter flask and use the wrench to tighten the filter bottle cap at all levels. 5, the right amount of raw material belt wrap the outlet of the pressure tank, attached to a pressure barrel ball valve PE pipeline post carbon inlet water pressure tank ball valve connected. 6, the inlet pipe connection: Under Sink Water Purifier machine is installed directly at the inlet valve of the pipeline access machine filter barrel water interface; cabinet machine installation, first open the lower part of the cabinet pipelines and wires import and export manhole cover leads to the power cord and the water ball valve connected to the pipe through the hole, lead to the cabinet and received the machine first stage filter barrel inlet connector, and then check whether the connector infiltration water. , Rinse pre-filter: First remove the reverse osmosis membrane shell water short PT tube is inserted into a container, open water and power supply, rinse the filter of the first three Road, directly to the water is clear. 8, the installation of the faucet: nail in a stainless steel sink and hit a small groove (easy drilling), hand drill (the M12 drill bit) to punch in the groove surface. Then fixed gooseneck faucet, gooseneck faucet termination 1 | 4PE tube and the other end connected to the export of activated carbon filter. Template shell wrench to remove the RO membrane cover, into the RO machine membrane and RO membrane cover, and use a wrench to tighten the film cover. 10, take the appropriate 1 | 4PE pipeline connected to the wastewater mouth, and into the next pipe. 11, open the water supply and gooseneck faucet, check that the high-pressure pump is working properly. Upon gooseneck faucet water, turn off the faucet,